INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double hung windows with actual clear opening widths of 22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear vertical opening of 14 inches (356mm). Side louvers and the rear of the air conditioner must have clear
air space to allow enough airflow through the condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
ELECTRICAL SERVICE
Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on left side of cabinet).
All models are equipped with a
The carton is the best way to store unit during winter or when not in use.
INSTALLATION | HARDWARE |
| ||
ITEM A: 11EA | ITEM B: 4EA | |||
SHORT SCREW | WOOD SCREW | |||
|
|
| ? | |
ITEM | C: 3EA | ITEM | D: lEA | |
L BRACKET | SEAL STRIP | |||
|
|
| (Adhesive | backed) |
ITEM | E: lEA | ITEM | F: 2EA | |
SASH | SEAL | GUIDE | PANEL | |
(Not adhesive | backed) |
|
|
ITEM G: lEA
DRAIN PIPE
To avoid risk of personal injury, pmper_ damage, or product damage due to the weight of this
device and sharp edges that may be exposed:
•Air conditionerscoveredin this manual pose an
excessiveweight hazard. Two or more people are needed to move and installthe unit.
To prevent injuryor strain,use properliftingand carrying techniques when moving unit.
•Carefully inspect location where air conditioner will be installed. Be sure it will support the
weight of the unit over an extended period of time,
•Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the
unit, AVOID the sharp metal fins of front and rear coils.
•Make sure air conditioner does not fall during installation.
REQUIRED TOOLS:
•Tight Fitting gloves
•Standard screwdriver
•Phillips screwdriver
•Pliers
•Sharp knife
•Carpenters level
•
•
•Tape measure
•Electric drill
-