INSTALLATION REQUIREMENTS INSTALLATION HARDWARE
Your air conditioner will install into standard double
hung windows with actual clear opening widths of 29 to 4t inches (737mm to 1041mm) (FIG, 1)
Lower sash must open sufficiently to allow a clear
vertical opening of 18 inches (457mm). Side louvers and the rear of the air conditioner must have clear
air space to allow enough airflow through the condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage,
l
Interiorwall | ..- | FIG. t |
ELECTRICAL SERVICE
Check your available electrical service. The power supply available must be the same as that shown on the unit nameplate (found on right side of cabinet).
All models are equipped with a
make the necessary corrections.
SAVE CARTON and this OWNER'S MANUAL for future reference. The carton is the best way to store unit during winter or when not in use.
To avoid risk of personal injury,property damage, or product damage due to the weightof this device and sharp edges that may be exposed:
•Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit.
To prevent injury or strain, use proper lifting and carrying techniques when moving unit.
•Carefully inspect location where air conditioner will be installed.Besure it will support the
weight of the unit over an extended perior of time.
°Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils.
°Make sure air conditioner does not fall during installation.
AB C D E
F G H I J K
|
| FIG. 2 |
ITEM | NAME OF PARTS | Q'TY |
A | SIDE CURTAIN | 2 |
B | SUPPORT BRACKET | 2 |
C | SILL BRACKET | 2 |
D | LOCK NUT | 4 |
E | SCREW: 25/64" | 11 |
F | SCREW: 13/1#` | 7 |
G | SCREW: 9/16" | 5 |
H | 2 | |
I | CARRIAGE BOLT | 2 |
J | FOAM STRIP | 1 |
K | FOAM SEAL | 1 |
L | WINDOW LOCKING BRACKET | 1 |
M | DRAIN PIPE | 1 |
REQUIRED TOOLS:
°Tight Fitting gloves
•Standard screwdriver
•Phillips screwdriver
•Pliers
•Sharp knife
•
•
•Tape measure
°Electdc drill
°