Kenmore 580.72184 owner manual Installation, How To Install, trackhole

Models: 580.72184

1 23
Download 23 pages 59.29 Kb
Page 6
Image 6
INSTALLATION

INSTALLATION

Pick a location which will allow you to blow the cold air into the area you want, Windows used for installation must be strong enough to support the weight of the air conditioner. Good installation with special attention to the proper position of the unit will lessen the chance that service will be needed. When cooling more than one room, installation location is very important since cold air will not turn corners. To cool your rooms, cold air must be blown from the air conditioner in a straight path.

_] Insert the side curtain(ITEM A) into the upper guide and lower guide of the air conditioner. Fasten the curtains to the unit with screws (ITEM E).

Lower Guide

HOW TO INSTALL

BRemove the screws which fasten the cabinet at

the back and side of the unit. Save side screws. Discard back screws.

FIG. 3

B Slide the unit out of the cabinet by gripping the base pan handle and pull forward while bracing the _abinet.

_Open the window.Mark a line on the center of the

window inner sill, Loosely attach the sill bracket (ITEM C) to the support bracket (ITEM B) using the carriage bolt (ITEM I) and the lock nut (ITEM D).

ITEMI

_ Attach the sill bracket to the window sill using the screws (ITEM F). Carefully place the cabinet on the window inner sill and align the center mark on the angle front with the center line marked on the window

lner sill.

 

 

 

 

screw

 

 

nut

trackhole

 

Outer

 

 

windowsill

Carriagebolt

 

F

andlocknut

Sill

FIG. 8

FIG. 4

_Cut the FOAM STRIP (ITEM J) to fit the underside of the window sash. Peel off the backing and attach the FOAM STRIP as shown in Fig. 5.

FIG. 5

BUsing the M-screw (ITEM H) and the lock nut

(ITEM D), attach the support bracket to the cabinet track hole. Use the first track hole after the sill bracket

on the outer edge of the window sill, Tighten the

carriage bolt and the lock nut, Be sure the cabinet slants downward 1/4" from level.

CAUTION: Do not drilla hole in the bottom pan, The unit is designed to operate with approximately 1/2" of water in bottom pan.

Cabinet

INDOOR

OUTDOOR

FIG, 9

-6-

Page 6
Image 6
Kenmore 580.72184 owner manual Installation, How To Install, trackhole