Kenmore 596.755024 manual Door and Drawer Removal

Installation

. Using the hex head driver, turn each of these adjustment screws (B) to raise or lower the rear of the refrigerator.

. Using the carpenter's level, make sure front of refrigerator is '/4"(6 ram) or '/2bubble higher than back of refrigerator and that the refrigerator is level from side to side.

6.Turn stabilizing legs (C) clockwise until firmly against floor.

7.Turn adjustment screws (A) counterclockwise to allow the full weight of the refrigerator to rest on the stabilizing legs.

8.Replace hinge cover(s).

•Position cover into the outer edge of the hinge.

•Swing the cover toward the cabinet and snap it into place.

9.Replace the toe grille.

Note

•For proper reinstallation, ensure the "top" marking on the interior of the toe grille is oriented correctly.

•Align the toe grille mounting clips with the lower cabinet slots.

•Push the toe grille firmly until it snaps into place.

Door and Drawer Removal

Some installations require door/drawer removal to transport the refrigerator to its final location.

To avoid electrical shock which can cause severe personal injury or death, observe the following:

•Disconnect power to refrigerator before removing doors or drawer. Connect power only after replacing doors or drawer.

To avoid damage to walls and flooring, protect vinyl or other flooring with cardboard, rugs or other protective material.

.

2.

Unplug power cord from power source.

Remove toe grille and bottom hinge cover(s) (see pages 7 and 8).

Remove top hinge cover from refrigerator door by removing Phillips screw and retain screw and cover for later use.

Unscrew %6"hex head screws from

top hinge to remove hinge and retain all screws for later use.

Lift right side refrigerator door from = = center hinge pin. Remove door

closure from center hinge pin on the right side and retain for later use.

Disconnect wire harness on top of left side refrigerator door top hinge.

Release two-pin connector by pressing junction point with a flat blade screwdriver or

fingernail.

Green ground wire remains attached to the hinge.

Unscrew %6,,hex head screws from

top hinge to remove hinge and retain for later use.

Lift left side refrigerator door, along with top hinge, from center hinge pin.

Remove center hinge pin with a _/,_.. hex head driver and retain hinge pin for later use.

Remove Phillips screws to remove right and left hinges and retain all screws for later use.

Remove both stabilizing brackets with %" hex head driver and retain screws for later use.

right side

Jdoor closure