Troubleshooting
Ice
Refrigerator is | • Plastic tubing was used to complete |
leaking water | water connection. |
• Improper saddle valve was installed.
(ce forms in | inlet | • Water pressure is too low. |
tube to ice | maker |
|
The manufacturer recommends using copper tubing for installation. Plastic is less durable and can cause
leakage. Sears is not responsible for property
damage due to improper installation or water connection.
Check water connection procedure (see page 12).
not responsible for property damage due to improper installation or water connection.
Water pressure must be between 35 to 100 pounds per square inch to function properly, A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters,
• Freezer temperature is too high.
Water | flow | is | • Water pressure is too low. |
smower | than | normal |
|
•Adjust freezer control (see page 14:).Freezer is recommended to be approximately 0° F
Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters.
• Improper saddle valve was installed.
• Copper tubing has kinks.
Check water connection procedure in your Installation Instructions.
property damage due to improper installation
or water connection. Open water valve completely and check for leaks.
•Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing.
28
