SECTION 3
CARE OF YOUR SOFTENER
3A. SALT… REFILLING STORAGE TANK/BREAKING A SALT BRIDGE
WHEN TO REFILL WITH SALT: Check the salt level a few weeks after you install the softener and every week after that. Refill when the storage tank is about 1/3 full. Never let the softener use all the salt before refilling. Without salt, you will soon have hard water.
IMPORTANT:
You will have a loss in softening capacity and may get partly hard water if less than 10 inches of salt is in the storage tank.
PLEASE SEE PAGE 8 FOR SALT FILLING DIRECTIONS.
SALT BRIDGE
Sometimes, a hard crust or salt bridge forms in the | FIG. 12 | A SALT BRIDGE |
salt storage tank. It is usually caused by high |
|
|
humidity or the wrong kind of salt. When the salt |
| push tool into salt |
bridges, an empty space forms between the water |
| |
| bridge to break | |
and salt. Then salt will not dissolve (melt) in the |
| |
|
| |
water to make brine. Without brine, the resin bed |
|
|
does not regenerate and you will have hard water. | 1º ± 2º | |
| ||
If the storage tank is full of salt, it is hard to tell if you have a salt bridge. Salt is loose on top, but the bridge is under it. The following is the best way to check for a salt bridge.
Salt should be loose all the way to the bottom of the tank. Hold a broom handle, or like tool, up to the softener as shown in FIG. 12. Make a pencil mark on the handle, 1, or 2, below the top height of the rim. Then, carefully push it straight down into the salt. If a hard object is felt before the pencil mark gets to the top of the tank, its most likely a salt bridge. Carefully push into the bridge in a few places to break it. Do not try to break the salt bridge by pounding on the outside of the salt tank. You may damage it.
If the wrong kind of salt made the bridge, take it out. Then fill the tank with nugget or pellet salt only.
Pencil
Mark
Broom Handle
Salt
Salt Bridge
Water Level
14
