SECTION 1
WATER SOFTENER
1E. FILL THE STORAGE TANK WITH SALT
Brine (salt dissolved in water) is needed for each and every regeneration. The water for making brine is metered into the salt storage tank by the softener. However, you must keep the tank filled with salt.
Fill the tank with NUGGET or PELLET water softener salt. DO NOT use rock salts, as they have dirt and sediments that will stop the softener from working.
Before filling, be sure the brinewell cover is in place on the top of the brinewell. Salt storage capacity is shown on page 21.
NOTE:
In humid areas, it is best to fill the storage tank half<full, and to refill it more often. Salt bridging (see page 14) occurs more often when conditions are humid.
WATER SOFTENING SALT WITH IRON RE- MOVING ADDITIVES Ð Some salts have an additive to help the softener handle iron in the water supply. Although this additive may help to keep the softener resin clean, it may also release corrosive fumes that will weaken and shorten the life of some softener parts.
FIG. 4
| Brinewell |
| Cover |
Salt |
|
Storage |
|
Tank | Brinewell |
SODIUM INFORMATION: Water softeners using sodium chloride for regeneration add sodium to the water. Persons who are on sodium restricted diets should consider the added sodium as part of their overall sodium intake.
For example, if your water supply is 15 grains hard, you would have to drink 3 quarts of softened water to consume 335 milligrams of sodium. That is equivalent to eating 2<1/2 slices of white bread.
Persons who are concerned about their drinking water should consider a Sears Drinking Water System that will remove or reduce in excess of 90% of the sodium and other drinking water contaminants.
You have now finished the water softener start up. After the sanitizing recharge, on page 7, the softener will be giving you soft water.
8
