SECTION 4
OTHER THINGS TO KNOW
4A. HOW TO
c. | Press the RECHARGE DAY button and | e. Press RECHARGE DAY button to display a | |
| SUnday begins to flash. | flashing TUesday, WEdnesday, etc., each time | |
±± If you want regenerations on Sunday (from | using the SET/CLEAR button to display ei> | ||
ther ON or OFF as needed. | |||
regeneration table), press the SET/CLEAR button | |||
| |||
to display ON. | After recharge is either set or cancelled for SAt> | ||
±± If you do not want Sunday regenerations, press | urday, press the PRESENT TIME AND DAY | ||
button once again to return the present | |||
the SET/CLEAR button to display OFF. | |||
time and day display. | |||
|
| ||
d. | Press the RECHARGE DAY button again to |
| |
| display a flashing MOnday and ON (factory set |
| |
| recharge). As you did in step c, use the SET/ |
| |
| CLEAR button to change the display from |
| |
| ON to OFF, or from OFF to ON. |
|
2. SET THE FILL CYCLE MINUTES
a. Press and hold the RECHARGE TIME button
until FILL shows in the display, then release
button . After a few seconds, the fill cycle minutes (factory setting… 16) will flash.
b. Press the SET/CLEAR button to set the min> utes of fill cycle needed, as shown in the re> generation table.
NOTE:
You may get hard water between regenerations if you set the timer for fewer fill minutes than the Regeneration Table shows you to set. A higher setting than needed will waste salt.
NOTE:
Press SET/CLEAR and quickly release to move the display ahead 1 minute at a time. Or, hold the SET/CLEAR button to move the display ahead 2 minutes each second. THE DISPLAY BEGINS OVER AT 0 AFTER PASSING 59.
c. Press PRESENT TIME AND DAY button to return the present time and day display.
TO SET the PRESENT TIME OF DAY, and DAY OF WEEK, see page 6.
If you need help to program the timer, call toll free,
number
19