CARE OF YOUR SOFTENER
SECTION 3
16
3B. KEEPING THE WATER SOFTENER CLEAN

COVERS

To keep your new Kenmore water softener looking
nice, apply a coat of paste wax and repeat once a
year.When dusty, wipe it with a damp cloth to keep
it sparkling.
NOTE:
Never use cleaners having ammonia or abrasives.
They may scratch and dull the surface.

NOZZLE & VENTURI

Aclean nozzle and venturi (FIG. 10) is a must for the
softener to work right. This small unit moves brine
from the salt storage tank to the resin tank during
regeneration. If it becomes plugged with sand, silt,
dirt, etc., the softener will not work and you will get
hard water.
Toget to the nozzle and venturi, remove the softener
top cover.Be sure the softener is in service cycle (no
water pressure at nozzle and venturi), then turn off
the cap from the nozzle and venturi housing. Donot
lose the large oĆring seal. Lift out the screen support
and screen, then the nozzle and venturi. Wash and
rinse the parts in warm water until clean. If needed,
use a small brush to remove iron or dirt. Also check
and clean the gasket flow plugs and screens.
Carefully replace all parts in the correct order.
Lubricate the oĆring seal with silicone grease or
Vaselineand place in position. Install and tighten
the cap, byhand only. Do not overtighten and
break the cap or housing.
FIG. 10 CLEANING THE NOZZLE &

VENTURI

*Install with numbered side up concave
side down. Be sure the largest flow plug is
located in the nozzle & venturi housing.
Cap
O–ring Seal
Screen Support
Screen
Nozzle & Venturi
Gasket
*Flow Plug
(HVDC)
Nozzle & Venturi
Housing
Screen
IMPORTANT: Be sure small
holes in the gasket are cen-
tered directly over the small
holes in the nozzle & venturi
housing.
*Flow Plug
(DUDC or DDUC)

IRON FROM THE RESIN BED

Your water softener takes hardness minerals (calĆ
cium and magnesium) out of the water. Also, it can
control some clear water" iron. See maximum
allowed in the specifications on page 19. With clear
wateriron, water from a faucet is clear when first put
into a glass. After 15 to 30 minutes, the water begins
to cloud or turn rust colored. A water softener WILL
NOTremove any iron which makes the water cloudy
or rusty as it comes from the faucet (called red water
iron).To take red water iron out of water, or over the
maximum of clear water iron, an iron filter or other
equipment is needed. Your local Sears store has
trainedpeople to help you with iron water problems.
If your water supply has clear water iron, even
though less than the maximum allowed, regular
resin bed cleaning is needed. Sears has resin bed
cleaner,Item No. 42Ć34426 for this. Clean the bed at
least every 6 months. If iron shows up in the soft
water before 6 months, clean more often. Printed
instructions are on the resin bed cleaner bottle.