water supply
fitting
3/8" black tubing _
II
II
II 1/4" red tubing
/blue tubing
NOTE: Tubing lengths should allow access to the
back of the assembly for servicing.
NOTE: Codes in the state of Massachusetts require
installation by a licensed plumber and do not permit
the use of saddle valves. If you live in the state of
Massachusetts, review plumbing code 248-CMR of
the Commonwealth of Massachusetts before pro-
ceeding with the installation.
CE) CE)
iIOT COLD /
sink p-trap 1/4" green tubing 3/8" yellow tubing
connector
Tube Connections

Figure 21

CONNECT YELLOW TUBE TO STORAGE TANK
1. Locate the yellow tube. One end is attached to the Reverse
Osmosis filter assembly.
2. Run the other end of the yellow tube to the fitting on top of
the storage tank. See Figure 21.
3. Cut tube square and to length. SeeFigure 16.
4. Donot connect at this time. This will occur in the sanitizing
step.
CONNECT GREEN TUBE TO COLD WATER
SUPPLY PIPE
1. Run one end of the 1/4" green tube to the fitting on the water
supply pipe. SeeFigure 21.
2. Cut tube square and to length. See Figure 16.
3. Connect to saddle valve. This is a compression fitting.

CONNECT RED TUBE TO REVERSE OSMOSIS

FAUCET

The red tube cortnection was completed in the faucet assembly

steps.

CONNECT BLUE TUBE TO REVERSE OSMOSIS

ASSEMBLY

The blue tube cortnection was completed in the faucet assembly

steps.

CONNECT BLACK TUBE FROM REVERSE OSMOSIS
FAUCET TO DRAIN ADAPTER
1. Locate the 30" length of 3/8" black tube. One end is attached
to the faucet. Figure 21.
2. Theother end needs to be attached to the black collet on the
sink drain adapter.
3. Cut this tube as needed to route in as straight of a run as
possible, without loops, dips, low spots or kinks.
4. Cut the end of the tube square. See Figure 16.
5. Insert all the way into the fitting. See Figures 17 & 18.
6. Pull on the tube to be sure it isheld firmly in the fitting.
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
15