Kenmore 625.38811 owner manual Check List of STEP-BY-STEP Guides to Install, Service?

SECTION1 WATER SOFTENER START UP

B. CHECK LIST OF STEP-BY-STEP GUIDES TO INSTALL

_lb be sure you have done all the steps to install the

softener, read the following list. Refer to the Instal-

lation Manual, part no. 7267336, for step-by-step

guides.

Page numbers referred to are in the Installation

Manual unless otherwise noted.

m" Is the house water flow going INTO the softener									VALVE
									INLET
valve INLET?		"lYace piping to be				sure. See pages
2-4 and 2-5.
m" Is the plumbing		bypass		valve (or		3 valves) set for
SERVICE?	Bypass		valve(s)		should		always	re-
main in	soft	water	service		position.		Position	in
"bypass"	only	if needed		for	softener		repairs.	See

FIG. 14, page 4-1 of this manual.

Is the valve drain hose connected the right way,

and without sharp bends or kinks that could stop or reduce water flow? See page 3-5 in the

installation manual.

Manual		unless	otherwise		noted.				3va,veJl
Page	numbers referred to are in the Installation
m" Is	the	transformer		plugged		into	an inside,	al-
ways		live,	grounded,		120V-60Hz		electrical	out-	plastic
let? See pages 3-8 and 3-9 in the installation
manual, and the wiring schematic on page 5-1 of
this	manual.

Bypass Valve(s)

Be sure to restart the water heater. See page 3-9.

NOTE; Codes in the state of Massachusetts require installation

by a licensed plianber. For installation, use plumbing, code

Z48- CMR of the Commonwealth of Massachusetts.

1-2

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line