Kenmore 721.7915 manual Microwave Oven Does Not Work, Cooking Times, Tu Rntable, Tones

Most cooking problems often are caused by little things that you can find and fix without tools of any kind. Check the lists below and on the next page before calling for assistance or service, if you still need help, call Sears Service at 1-800-4-MY-HOME.

MICROWAVE OVEN DOES NOT WORK

PROBLEM	CAUSE
Nothing works.	• The power			supply	cord is not		plugged		into a grounded		3 prong
	outlet. (See the "Electrical Requirements" and "Electrical Connection"
	sections)
	• A household fuse has blown or a circuit breaker has tripped.
	• The	electric		company		has had a		power	failure.
The microwave oven will	• You	are	using the		oven	as a timer.		Touch STOP		to cancel
not run.	the	Kitchen		Timen
	• The	door	is	not firmly		closed	and	latched.
	• You	did	not	touch	START.
	• You	did	not	follow	directions		exactly.
	• An	operation		that	you	set earlier		is still	running.	Touch	STOP to cancel
	that	operation.

COOKING TIMES

PROBLEM

Food is not cooked enough.

The display shows a time counting down but the oven is not cooking.

TU RNTABLE

PROBLEM

The turntable witl not turn.

CAUSE

•The electric supply to your home or walt outlets is tow or lower than normat. Your electric company can tell you if the line voltage is low. Your electrician or service technician can tett you if the outlet voltage iSlOW.

•The cook power is not at the recommended setting.

•Refer to Cooking Tip chart.

•The oven door is not closed completely.

•You have set the controls as a Kitchen Timer. Touch STOP to cancel the Kitchen Timer.

CAUSE

•The turntable is not correctly in place or the turntable could be in the turntable "OFF" mode. The glass plate should be correct-side up and sitting firmly on the center shaft.

•The support is not operating correctly. Remove the turntable and restart the oven. If the support still does not move, call Sears Service at 1-800-4-MY-HOME ®. Cooking without the turntable can give you poor results.

TONES

PROBLEM

You do not hear the programming or end-of-cycle tone.

CAUSE

• You have not entered the correct command.

28