AIR CONDITIONER FEATURES
The controls featured in this manual are
representative of the many models available. Your model may look slightly different,
| e5 |
| OFF |
|
3e 41 | °6 07 | MED | • | HIGH |
2o | '='8 | ii_ |
| •COOLMED |
|
| LOWFAN_• |
| |
|
| FA |
| COOL |
|
|
| LOW COOL |
|
| TEMP |
| MODE |
|
TEMP
The thermostat wil! automatically control the temperature of the room. Select a higher number for lower room temperature. The temperature is selected by turning the TEMP knob to the desired position.
The 5 or 6 position is a normal setting for average
conditions.
MODE
OFF :Turns the air conditioner off,
MED FAN : Permits the medium fan speed operation without cooling.
LOW FAN : Permits the low fan speed operation without cooling.
HIGH COOL : Permits cooling with the high fan
speed operation.
MED COOL : Permits cooling with the medium fan speed operation.
LOW COOL : Permits cooling with the low fan
speed operation.
VENT CONTROL
The Vent Control allows the air conditionerto either recirculate inside air (CLOSE) or exhaust air to the outside (OPEN).
•The CLOSE position is used when maximum cooling is desired. It may also be used for air recirculation without cooling when the air conditioner Lsset in the FAN position.
•The OPEN position removes stale air from the room and exhausts it to the outside. Fresh air is
drawn into the room through normal air passages found in homes.
•The OPEN or CLOSE position can be used with any fan selection.
PULL OPEN I PUSH CLOSE
VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the louver upward or downward.
DRAINAGE
First, be sure to insert the drain pipe into base pan before installation.
The air conditioner must be installed with a slight tilt to the outside for proper water drainage.
The air conditioner will drain the excess condensed water through the drain pipe.
_r_BASE PAN REAR
DRA_
"_'1///////////////_.
\
BASE PAN
