Setting Warmer Drawer Controls

Arranging Warmer Drawer (Warm & Ready TM

Drawer) Rack Positions (some models)

Note: Use the warmer drawer to keep hot foods hot such as: vegetables, gravies, meats, casseroles, biscuits and rolls, pastries and heated dinner plates.

The rack can be used in 2 ways:

In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish under - See Fig. 1).

In the downward position to allow you to place light weight food items and empty dishware (for example, rolls or pastries and dinner plates - See Fig. 2).

The warmer d rawer is equipped with a catch which may require extra force when opening and closing the drawer.

2.For best results, preheat the drawer before adding food. An empty drawer will preheat in approximately 15 minutes.

3.Turn the thermostat control to OFF after use.

Warmer (Warm & Ready TM) Drawer Temperature Selection (some models)

Refer to the table in the side column for recommended settings. If a particular food is not listed, start with the medium setting. If more crispness is desired, remove the lid or aluminum foil.

Most foods can be kept at serving temperatures by using the medium setting.

When a combination of foods are to be kept warm (for instance, a meat with 2 vegetables and rolls), use the high setting.

Refrain from opening the warmer drawer while in use to eliminate loss of heat from the drawer.

WARMER DRAWER

j

¢

 

 

 

J

 

Warmer Drawer Recommended Food Settings Table

Food Item

 

 

Setting

Bacon & Hamburger

Patties

HI

Poultry & Pork Chops

HI

Fried Foods & Pizza

 

HI

Gravies, Eggs, Vegetables & Casseroles

MED

Roasts (Beef,

Pork, Lamb)

MED

Biscuits, Hard

Rolls

& Pastries

MED

Soft Rolls or empty Dinner Plates

LO

i j_

.

2

Fig. 3

.zJ_ig.

 

 

To Operate the Warmer (Warm & Ready TM)

Drawer

Always start with hot food. It is not recommended to heat cold food in the warmer drawer.

Warmer (Warm & Ready TM) Drawer indicator

Light (some models)

The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on until the control is turned OFF.

All food placed in the warmer drawer should be covered with a lid or aluminum foil to maintain quality. Do not use plastic wrap to cover food. Plastic may melt onto the drawer and be very difficult to clean.

Use only dishes, utensils and cookware recommended for oven use in the warmer drawer.

Always use pot holders or oven mitts when removing food from the warmer drawer as cookware and plates will be HOT.

To Set the Warmer (Warm & Ready TM) Drawer Thermostat Control (some models)

The thermostat control is used to select the temperature of the warmer drawer. It is located on the control panel (See Fig. 3 on previous page). To set the thermostat, push in and turn the knob to the desired setting. The temperatures are approximate, and are designated by HI, MED and LO.

1.Turn the knob to select the desired temperature setting.

The warmer drawer is inoperable during the Self-Clean cycle. The warmer drawer indicator light will not come on during the Self-Clean cycle.

NOTE: The warmei drawer Wi!!NOT Opeiate while in the Self-Clean &'!Oven Lockout" modes

15

Page 15
Image 15
Kenmore 7881, 7891, 7882, 7877, 7878, 7895, 7864 manual Setting Warmer Drawer Controls