Oven Controls
Figure 22: Hot (L) and door OPn (R)
When Self Clean is Finished
1.The Cln message will turn off, and Hot will appear in display window (See Figure 22).
2.Once the oven has cooled down (about 1 hour) and Hot is no longer displayed, the door Opn message will appear. When this message turns off, the oven door may be opened.
3.When the oven interior has completely cooled, wipe away any residue or powdered ash with a damp cloth or paper towel.
Use caution when opening the oven door after self cleaning. The oven may still be very hot and can cause burns. To avoid possible burns, stand to the side of the oven when opening the oven door to allow hot air or steam to escape.
Important note:
The kitchen area should be well ventilated. Use an open window, ventilation fan, or exhaust hood during the first self clean cycle to help eliminate the normal odors associated with the initial self clean cycle.
When the clean time finishes, the oven door will remain locked until the oven has cooled sufficiently. In addition to the clean time that was programmed, allow about 1 additional hour for the oven to cool before opening the oven door. The Self Clean function will not operate when the oven lockout is active.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3 hours and a start time of 9:00 o’clock:
1.Be sure the clock is set with the correct time of day, the oven is empty, and all of the oven racks are removed. Be sure oven door is completely closed.
2.Press Delay Start.
3.Using numeric keypad, enter 9 0 0 for time to start.
4.Press 
to accept.
5.Press Self Clean.
6.Press 
.
If it becomes necessary to stop Self Clean when active:
1.Press STOP .
2.If Self Clean has heated the oven to a high temperature, allow enough time for the oven to cool and the door Opn
message to appear (See Figure 22). When this message turns off, the oven may be opened.
3.Before restarting Self Clean, be sure to read important notes below.
Important note:
•When Self Clean is active, you may check the amount of clean time remaining by pressing the Self Clean key once.
•If your clock is set with the (default) 12 hr display mode, the Delay Start for a Self Clean can only be programmed to start up to 11 hours and 59 minutes after the time showing in the display (be sure to set the clock to current time before programming a delay start). To set a Delay Start Self Clean to begin 12 or more hours (maximum is 23 hours and 59 minutes) after the time of setting, be sure to first set the control in the 24 Hr display mode.
•If Self Clean was active and then interrupted by a power failure or cancelled before the oven was thoroughly cleaned, it may be necessary to run another Self Clean cycle.
•If the oven temperature was high enough when Self Clean was interrupted, the oven control may not allow another Self Clean cycle to be set for up to 4 hours.
18
