Kenmore 790.31 General Care & Cleaning, Cleaning Various Parts of Your Cooktop, difficult soils

Models: 790.31 790.3101

1 14
Download 14 pages 7.91 Kb
Page 11
Image 11
General Care & Cleaning

General Care & Cleaning

Cleaning Various Parts of Your Cooktop

Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE DIFFICULTY AND EXTENT OF A MAJOR CLEANING LATER.

Surfaces

 

 

How to Clean

 

 

 

 

 

Aluminum (Trim Pieces) &

Use hot, soapy water

and a cloth or paper

towel. Dry with a clean

cloth.

 

Vinyl

 

 

 

 

 

 

 

 

Painted

and

Plastic Control

For general cleaning,

use hot soapy water

and a cloth. For more

difficult soils

and

Knobs, Body

Pieces, and

built-up grease, apply a liquid detergent directly onto the soil. Leave

on soil for 30 to

DecorativeTrim

60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive

cleaners

on any

 

 

 

of these materials; they can scratch or dull the finish.

 

 

 

Control

Panel

Wipe the control panel clean after each use. Before cleaning the control panel, turn all

 

 

 

controls to OFF and remove the control knobs. To remove, pull each knob straight off

the shaft. Clean using hot, soapy water and a cloth. Be sure to squeeze excess water from the cloth before wiping the panel; especially when wiping around the controls. Excess water in or around the controls may cause damage to the appliance. To replace knobs after cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place.

Stainless Steel, Chrome Decorative Trim

Porcelain Enamel

Burner Grates, Burner Pans (some models), Burner Rings (some models), Cooktop Surface

Surface Burners

Clean with hot, soapy water and a dishcloth. Rinse with clean water and cloth. Do not use cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel. Always be sure to rinse the cleaners off from the surface as bluish stains may occur during heating that cannot be removed.

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution of clear water and ammonia, ffnecessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth or paper towel. Remove all cleaners or the porcelain may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop.

The holes in the burners of your cooktop must be kept clean at all times for proper ignition and a complete, even flame. Clean the burner holes routinely with a small gauge wire or needle and especially after bad spillovers which could clog these holes.

To remove and replace burner units per your model, see instructions under General Cleaning. To clean, soak the burners in a 1:1 solution of ammonia and water for 30 to 40 minutes. For stubborn stains, scrub with soap and water or a mild abrasive cleanser and damp cloth. Dry the burners thoroughly in a warm oven for 30 minutes.

Then replace them, making sure they are seated and level. DO NOT wash burner units in the dishwasher.

11

Page 11
Image 11
Kenmore 790.31 General Care & Cleaning, Cleaning Various Parts of Your Cooktop, For general cleaning, difficult soils