Setting Surface Controls (cont'd)
Setting the Bridge Burner
The Bridge Burner should be used with rectangular supplied with your cooktop is designed specifically
shaped cookware. Cookware like the
The Bridge Burner feature may be used to combine the cooking power of 2 or if needed 3 gas surface Burners located along the
Operating the Bridge Burner
1.Push the left rear surface control knob in and turn
counterclockwise out of the OFF position (See Figure).
2.Release the knob and rotate to the LITE position (See Figure). Note: All electronic surface ignitors will spark at the same time. However, only the selected surface Burner will lite.
3.Visually check that the left rear Burner has lit.
4.Continue to rotate the gas control knob counterclockwise past the first LO setting to the arrow marked Multi.
5.Visually check that both the [eft rear and left center Burners are lit. Adjust the flame size by turning the control knob between the second Hi and LO settings (See Figure).
6.Add the left front Burner if needed. Once lit, visually adjust the flame size of the left front Burner to match the flame size of the
Bridge Burner. | Off | Hi | Lo Multi Hi | Lo |
7.Place cooking utensil centered over the
Note: if only the left rear surface Burner is needed, follow the instructions provided below.
Operating only the Left rear Gas Surface Burner
1.Place cooking utensil centered over the
2.Push the left rear surface control knob in and turn counterclockwise out of the OFF position (See Figure).
3.Release the knob and rotate to the LITE position. Note: All electronic surface ignitors will spark at the same time. However, only the [eft rear Burner will ignite.
4.Visually check that the
10