Set POWER to “CAMERA”.
Tape length and recording mode indicator
T30 SP 
T30 SP 
T30 LP
T45 LP 
T45 SP
9
Viewfinder Adjustment
POSITION VIEWFINDER
1 Adjust the viewfinder manually for best viewability (see illustration at left).
SELECT MODE
2 Set the power switch to CAMERA.
ADJUST DIOPTER
3 Turn the diopter adjustment control until the indications in the viewfinder are clearly focused.
Tape Length/Recording Mode Setting
SET TAPE LENGTH
1 Set the tape length button according to the length of the tape used. T30 = 30 minutes of recording time and T45 = 45 minutes (in SP).
SET RECORDING MODE
2 Set depending on your preference. “SP” (Standard Play) provides higher picture and sound quality and is better for dubbing, while “LP” (Long Play) is more economical, recording at 1/2 the speed of SP.
NOTE:
The tape remaining time indicator does not work with tapes other than EC30 and EC45. (See Basic Recording on pg. 12 for “tape remaining time indicator”.)
Turn to take up 
slack.
Erase Protection Gear
Loading/Unloading A Cassette
OPEN CASSETTE HOLDER
1 Slide EJECT until holder opens. Do not use force to open.
INSERT/REMOVE CASSETTE
2 Make sure label is facing outward.
CLOSE CASSETTE HOLDER
3 Press PUSH and make sure the holder is closed and locked.
NOTES:
●A cassette holder can't be opened unless a power supply is attached.
●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.
●Make sure the Erase Protection tab is present. If not, cover the hole with adhesive tape. (Some cassettes have sliding tabs – in this case, check the tab’s position.)
9 |
96.10.8, 1:25 PM
