96.10.8, 1:25 PM
”, 15S is automati-
NOTE:
If the PROGRAM AE dial is set to “ cally selected.
START DELAYED RECORDING
3 Press Recording Start/Stop. The tally lamp begins blinking, and the blinking speed increases about
5 seconds before recording starts. When recording begins, the lamp stops blinking but stays lit.
RELEASE SELF-TIMER MODE
4 To release when the tally lamp is not blinking, press INTERVAL continuously until “ ” disappears. To release when the tally lamp is blinking, press Recording Start/Stop to stop the blinking, then press INTERVAL continuously until “ ” disappears.
SET TIME DELAY
Make sure the lens cover is open, set the power switch to CAMERA.
1
2 On the RM-V20U, press INTERVAL to set the delay time. There are four choices, and they appear in the viewfinder in the following order (each time INTERVAL is pressed): 15S (15 seconds), 30S
(30 seconds), 1MIN (1 minute) and 5MIN
(5 minutes). Pressing again releases the Self-timer.
You can set the delay between pressing Recording Start/ Stop and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.
NOTE:
You need the optional RM-V20U remote control unit to perform this procedure.
ENGAGE RECORD–STANDBY MODE
Advanced Features
24
RECORDING
Tally lamp PROGRAM AE
START/STOP
INTERVAL
REC TIME
RM-V20U (optional)
24 |
