PUMP ADJUSTMENT

!WARNING

BEFORE ADJUSTING THE PUMPS ON THE BRUSH BLAZER, USE A FLOOR

JACK TO RAISE THE TRACKS OFF OF THE GROUND. USE BLOCKS UNDERNEATH

THE MOWER DECK AND THE REAR CHASSIS TO SUPPORT THE MACHINE.

REVERSE

FRS RODADJUSTMENT BOLT

JAM NUT

HYDRAULIC

PUMP

JAM NUT

TRAVEL ADJUSTMENT:

1.With the machine securely supported on blocks, loosen the jam nut at the end of one or both FRS rods to be adjusted.

2.Turn the FRS rods either clockwise or counter clockwise until the tracks do not move when the machine idles.*

3.After making the necessary adjustments, tighten the jam nut at the end of one or both FRS rods.

*If the machine travels forward when idling, the FRS rods should be turned clockwise until the tracks do not move when the machine idles.

*If the machine travels in reverse when idling, the FRS rods should be turned counter-clockwise until the tracks do not move when the machine idles.

*If the machine pulls to the left when traveling forward, adjust the right FRS rod by turning the rod clockwise until the track does not move when the machine idles.

*If the machine pulls to the right when traveling forward, adjust the left FRS rod by turning the rod clockwise until the track does not move when the machine idles.

REVERSE SPEED ADJUSTMENT:

1.With the machine securely supported on blocks, loosen the jam nuts on both reverse adjustment bolts.

2.Turn the reverse adjustment bolts clockwise to slow the reverse speed or counter-clockwise to increase the reverse speed.

3.After adjustment, tighten the jam nuts on the reverse adjustment bolts.

!WARNING

DO NOT INCREASE THE REVERSE SPEED FASTER THAN

THE OPERATOR CAN SAFELY WALK BACKWARDS

14

Page 14
Image 14
Pecoware TBB-3000 owner manual Pump Adjustment, Reverse Speed Adjustment