CHARGING THE HYDRAULIC SYSTEM
!DANGER
DO NOT EXCEED MORE THAN 10 POUNDS OF PRESSURE WHEN CHARGING THE HYDRAULIC SYSTEM. FAILURE TO DO SO MAY RESULT IN SYSTEM FAILURE AND/OR PERSONAL INJURY.
CONTACT YOUR BRUSH BLAZER DEALER FOR THE HYDRAULIC CHARGING KIT ORDERING INFORMATION:
?HYDRAULIC CHARGING KIT (PART#:
(1)1/4” AIR REGULATOR WITH GAUGE (PART#:
(1)1/4” FEMALE COUPLER (PART#:
(1)1/4” MALE PLUG (PART#:
(1)HYDRAULIC OIL TANK CAP WITH FITTING (PART#:
(1)HYDRAULIC OIL TANK CAP DRILLED FOR 1/4” NPT (PART#:
(1)1/4” MALE PLUG (PART#:
TOOLS REQUIRED:
(1) AIR COMPRESSOR
(1)AIR HOSE WITH 1/4” FEMALE COUPLER
(1)CONTAINER FOR COLLECTING FLUID
(1)HYDRAULIC CHARGING KIT
PROCEDURE:
1.Loosen, but do not remove the charge relief valve on both hydraulic pumps. Figure 1
2.Disconnect the return line. Attach a hose to the end of the return line and use a suitable container to collect any fluid leakage that may occur. Figure 2
LOOSEN THE
CHARGE
DISCONNECT RETURN
RELIEF VALVE
LINE AND ATTACH HOSE
TO CONTAINER
FIGURE 1 | FIGURE 2 |
22
