General Care & Cleaning (cont'd)

Removing and Replacing Warmer (Warm & Ready TM) Drawer

in serious injury or death. Disconnect appliance from electric

'_'_power before cleaningElectricalandShockservicingHazardthe warmercanoccurdrawerand. result

To Remove Warmer Drawer:

1. I_:_[_Turn

poweroff before removing the warmerdrawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1).

4.Pull the drawer away from the range.

To Replace Warmer (Warm & Ready TM) Drawer:

1.Pull the bearing glides to the front of the chassis glide (See Figure 2).

2.Align the glide on each side of the drawer with the glide slots on the range.

3.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.

NOTE: The Warmer Drawer will NOT operate while in the "Self-Clean" and "Oven Lockout" modes

Left Glide

Pull up latch

 

with finger

Pull down latch

with finger Figure1 Right Glide

Changing

the

Oven Light

 

 

 

 

The oven lights will automatically turn ON when the oven door is opened. The

 

 

oven lights

may

also be manually

operated by pressing the _

pad.

 

 

 

 

 

 

ON/OFF

 

 

The lamp is covered with a glass shield. The glass shield can be removed to be

 

 

cleaned manually or to change oven light. THIS GLASS SHIELD MUST BE IN

 

 

PLACE WHENEVER THE OVEN IS IN USE.

of glass shield

 

 

 

 

 

 

To replace the light bulb:

 

and remove

it.

Halogen

 

 

 

 

 

 

Light Bulb

CAUTION:

BE SURE THE OVEN

IS COOL.

 

 

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.To remove the glass shield, pull the back side of the shield toward the inside of the oven in a manner to lift it up from the oven side.

4.The glass shield should come out easily by pushing a little toward front of the range.

5.Replace halogen light appliance bulb taking care not to touch the bulb with your bare fingers. Touching bulb with your skin can leave a film on the bulb that causes it to burn out quickly.

6.Replace glass shield in opposite order and manner of removal.

40

Page 40
Image 40
Kenmore 790.4660 manual Changing Oven Light, Place Whenever the Oven is in USE, Be Sure the Oven Is Cool