Kenmore 790.75609 To Remove and Replace Warmer Warm & Ready TM Drawer, To Remove Warmer Drawer

Setting Warmer Drawer Controls

Removing and Replacing Warmer Drawer

Warmer (Warm & Ready TM) Drawer Indicator Light

The indicator light is located above the warmer drawer thermostat control. It turns on when the control is set, and stays on until the control is turned off. The warmer drawer is inoperable during the self-clean cycle. The indicator light will not come on during the self-clean cycle.

[]

Push down with finger

Figure 1

To Remove and Replace Warmer (Warm & Ready TM ) Drawer

To Remove Warmer Drawer:

1. _ Turn power off before removing the warmer drawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (see figure 1).

5.Pull the drawer away from the range.

To Replace Warmer (Warm & Ready TM) Drawer:

1.Pull the bearing glides to the front of the chassis glide (see figure 2).

2.Align the glide on each side of the drawer with the glide slots on the range.

3.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.

NOTE: The Warmer Drawer will NOT operate while in the Self:Clean and "Oven Lockout" modes

!rl_lW'-'l;t_ll_l'tllElectrical Shock Hazard can occur and result in

serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer.

ng Glide

Figure 2

16