Kenmore 790.75602, 790.75604, 790.75609 manual Before You Call, Occurrence, Possible Cause/Solution

OCCURRENCE

Oven smokes excessively during broiling.

Oven Control Errors

Oven control beeps and displays F1, F3 or F9.

Poor baking results.

Self-Cleaning cycle does not work.

Soil is not completely removed.

Flames inside oven or smoking from vent.

Before You Call

Solutions to Common Problems

POSSIBLE CAUSE/SOLUTION

Meattee close to the broil burner. Repositien the rack to provide more clearance between the meat and the broiler.

Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges to prevent curling, but do not cut into the lean.

Broiler pan used without insert or insert covered with foil. DO NOT use the broiler pan without the insert or cover the insert with foil.

Broiler drawer needs to be cleaned. Excessive smoking is caused by a build-up of grease or food spatters. If the broiler is used often, clean on a regular basis.

Broiler drawer is open. Drawer/door should be closed when broiling.

This oven is equipped with a state of the art electronic oven controller. Among its many features is a full time oven circuit diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits to insure they are all operating correctly. If at any time one of these systems fails, the controller will immediately stop operation, and beep continuously (flashing an error code of F1, F3 or F9 in the display window, if equipped).

Electronic control has detected a fault condition. Push OFF/CANCEL to clear the display _I_'_ and stop beeping. Repregram oven. If fault recurs, record fault number. Push OFF/ 2_ CANCEL and contact a Sears Service Center.

Many factors affect baking results. Make sure the proper rack position is used. Center _"o_ food in the oven and space pans to allow air to circulate, Allow the oven to preheat to _f_

the set temperature before placing food in the oven. Try adjusting the recipe's _[_ recommended temperature or baking time, If you feel the oven is cooking tee hot or cool,

see Adjusting Your Oven Temperature.

Controls are not set properly. Follow instructions in Self-Cleaning section.

Self-cleaning cycle was interrupted. Stop time must be set 2 to 4 hours past the start time. Follow steps under "Stopping or Interrupting a Self-Clean Cycle" under Self Cleaning.

Failure to clean bottom front, top of oven or door areas outside oven seal. These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before starting the self-clean cycle, Burned*on residue may be cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful net to damage the oven gasket.

Excessive spillevers in oven. Set self-clean cycle for a longer cleaning time.

Excessive spillevers in oven, This is normal, especially for pie spillevers or large amounts of grease on the oven bottom. Wipe up excessive spillevers before starting the self*clean cycle. If flames or excessive smoke are present, stop the self-clean cycle and follow the steps under "Stopping or Interrupting the Self-Clean Cycle" in the Self Cleaning section.

23