Kenmore 790.75602 manual Care & Cleaning, To Remove and Replace Oven Door, To Remove Oven Door

Care & Cleaning

Cleaning the Contoured Well Areas, Burner Cap and Burner Head

The contoured well areas, burner cap and burner head should be routinely cleaned. Keeping the burner ports clean willprevent improper ignition and an uneven flame. Refer to the following instructions:

Surface

BurRer

E--

To Clean the Recessed and Contoured Areas of the Cooktop- Ira spill occurs on or in the recessed orcontoured areas, blot up spill with an absorbentcloth. Rinse with a clean, damp cloth and wipe dry.

To Remove and Replace the Surface Burner Caps and Surface Burner Heads - Remove in the following order: (1st) surface burner grate, (2nd) surface burner cap, (3rd) surface burner head.

Reverse the procedure above to replace the surface burner cap and surface burner head. Do not remove any parts from the cooktop until they have completely cooled and are safe to handle. Do not operate the surface burners without the surface burner cap and surface burner head properly in place.

Surface

_	Burner
	Head

_rlflce

Holder,

To Clean the Surface Burner Cap and Surface Burner Head - Use a soap-filled scouring pad or a mild abrasive cleanser to clean the surface burner caps and surface burner heads. The ports (or slots) around the burner head must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes. For proper flow of gas and ignition of the burner--DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface burner cap and surface burner head in place whenever a surface burner is in use.

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

Use caution when replacing the burner cap so the electrode is not damaged. This may ca use a delayed ignition

or prevent the burner from igniting.

Any	additions,	changes or conversions	required in order for this appliance to perform satisfactorily must be /
made by an author	zed Sears	Serv ce Center.	J

To Remove and Replace Oven Door

To Remove Oven Door:

1.Open the door.

2.Remove screws located on the inside of the oven door near the hinges A (one on each side.)

3.Close the door to the quarter-open position. Grasp the door firmly on both sides and lift up and off the hinges.

4.To clean oven door, follow the instructions provided in the Care & Cleaning table.

To Replace Oven Door:

1.Be sure the hinge arms are in the quarter-open position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers.

2.Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the door.

3.Hinge arms must go into the range slots evenly. The hinge arms should be inserted into the bottom corners of the door as far as they can go.

4.If the door is not in line with the oven frame, remove it and repeat the above steps.

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

20