Kenmore 790.9007 manual Before Setting Oven Controls, Setting Surface Controls, Oven Vent Location

Models: 790.9081 790.9004 790.9007 790.9005 790.9083 790.9103 790.9104 790.9003 790.9006

1 16
Download 16 pages 56.71 Kb
Page 6
Image 6
Before Setting Oven Controls

Before Setting Oven Controls

Oven Vent Location

For models equipped with coiled surface elements, the oven vent is located under the left rear surface element. When the oven is on, warm air flows through the left rear element. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT BLOCK THE OVEN VENT.

Arranging Oven Racks

ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO

OPERATING THE OVEN). Always use oven mitts when using the oven.

Removing & Replacing Oven Racks

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

Setting Surface Controls

To Operate the Surface Elements:

1.Place cooking utensil on the surface element.

2.Push in and turn the surface control knob in either direction to the desired setting. Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. The control knobs do not have to be set exactly on a particular setting. Use the settings as a guide and adjust the control knob as needed.

3.When cooking is completed, turn the surface element off before removing the pan. Note: The surface “Element On” indicator light(s) will glow when one or more elements are turned on. A quick glance at these indicator light(s) when cooking is finished is an easy check to be sure all surface elements are turned off.

The suggested settings found in the chart below are based on cooking in medium-weight aluminum pans with lids. Settings may vary when using other types of pans.

SURFACEELEMENTS

Setting

Type of Cooking

 

 

HIGH (HI - 9)

Start most foods, bring water to a boil, pan broiling

 

 

MEDIUM HIGH (7 - 8)

Continue a rapid boil, fry, deep fat fry

 

 

MEDIUM (5 - 6)

Maintain a slow boil, thicken sauces and gravies, steam vegetables

 

 

MEDIUM LOW (2 - 4)

Keep foods cooking, poach, stew

 

 

LOW (LO - 1)

Keep warm, melt, simmer

 

 

Oven Vent LocationArranging Oven RacksRemoving & Replacing Oven RacksSetting Surface ControlsTo Operate the Surface Elements: Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.

6

Page 6
Image 6
Kenmore 790.9007 manual Before Setting Oven Controls, Setting Surface Controls, Oven Vent Location, Arranging Oven Racks