Kenmore 795.7205 manual Water Filter Bypass Plug

WATER FILTER

CHANGE FILTER

It is recommended that you replace the water filter:

*Approximately every six months. When the water filter indicator

turns on.

When the water dispenser output decreases.

When the ice cubes are smaller than normal.

]. Remove the aid water fliter.

Lower or remove the top left shelf to allow the water filter to rotate

all the way down.

Pinch the sides to open the water filter cover.

NOTE: Replacing the water filter causes a small amount of water

(around 1 oz. or 25 cc) to drain. Place a cup under the front end of the water filter cover to collect any leaking water. Hold the water filter upright, once it is removed, to prevent

any remaining water from spilling out of the water filter.

Pull the water filter downward and pull out. Make sure to rotate the filter down completely before pulling it out of the manifold hole.

2.Replace with a new water filter.

Take the new water filter out of its packing and remove the protective cover from the o-rings. With water filter tabs in the horizontal position, push the new water filter into the manifold hole until it stops.

Rotate the water filter up into position and close the cover. The cover will click when closed correctly.

. After the water filter is replaced, dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminates from

the system. Do not dispense the entire 2.5 gallon amount continuously. Depress and release the

dispenser pad for cycles of 30 seconds ON and 60 seconds OFF.

4.Water Filter Bypass Plug

Keep the water filter

bypass plug. You MUST use the water filter

bypass plug when a

replacement water _WaterFilter filter cartridge is not

available.

Bypass Plug

CAUTION: DO NOT operate refrigerator without water filter or water filter plug installed.

NOTE: To purchase a replacement water filter, visit a

Sears store or call 1-800-4-MY-HOME ®. Also, you may

order on-line at www.sears.com/partsdirect

29