Icemaker is not making enough ice (continued).
Dispensing water slowly.
Doors are opened often or for long periods of time.
Doors are not closed completely.
The temperature setting for the freezer is too warm.
Water filter has been exhausted.
Reverse osmosis filtration system is used.
Low house water supply pressure.
iCE & WATER
If the doors of the unit are opened often, ambient air will warm the refrigerator which will prevent the unit from maintaining the set temperature. Lowering the refrigerator temperature can help, as well as not opening the doors as frequently.
If the doors are not properly closed, ice production will be affected. See the Doors will not close
completely or pop open section in Parts & Features Troubleshooting for more information.
The recommended temperature for the freezer compartment for normal ice production is 0°F. If the freezer temperature is warmer, ice production will be affected.
It is recommended that you replace the water filter:
•Approximately every six months.
•When the water filter indicator turns on.
•When the water dispenser output decreases.
•When the ice cubes are smaller than normal.
Reverse osmosis filtration systems can reduce the water pressure below the minimum amount and result in icemaker issues.
If the problem persists, it may be necessary to contact a plumber.
The water pressure must be between 20 and 120 psi on models without a water filter and between 40 and 120
psi on models with a water filter.
If the problem persists, it may be necessary to contact a plumber.
Not dispensing ice. Doors are not closed completely.
Infrequent use of the dispenser.
The delivery chute is clogged with frost or ice fragments.
L
The dispenser display is locked.
Ice bin is empty.
Ice will not dispense if any of the refrigerator doors are left open.
Infrequent use of the ice dispenser will cause the cubes to stick together over time, which will prevent them from properly dispensing. Check the ice bin for ice
cubes clumping/sticking together. If they are, break up the ice cubes to allow for proper operation.
Eliminate the frost or ice fragments by removing the ice bin and clearing the chute with a plastic utensil. Dispensing cubed ice can also help prevent frost or ice fragment buildup.
Press and hold the Lock button for three seconds to unlock the control panel and dispenser.
It may take up to 24 hours for each compartment to reach the desired temperature and for the icemaker to begin making ice. Make sure that the shutoff (arm/ sensor) is not obstructed.
Once the ice supply in the bin has been completely exhausted, it my take up to 90 minutes before additional ice is available, and approximately 24 hours to completely refill the bin.
41
