BEFORE CALLING FOR SERVICE (cont.)
Door will not unlock when cycle is stop_d or paused
Check if,. | Then.,, |
Interiortemperature of washer is too high, | The washer door has a safety feature to prevent burns |
| For example, if the washer is paused during the hot wash portion of |
| a sanitary cycle, the interior temperature of the drum will be very hot, |
| so the door will not unlock. This is normal. Allow the washer to coo] |
| until the DOOR LOCK indicator turns off on the display. |
Water level in washer is too high, | Allow the washer to complete the programmed cycle, or press the |
| CANCELJDRA]Nbutton to drain the water, |
Wash cycle time is longer than usual
Check if,,.
amount of laundry,water pressure, water heating time, and
IThe washer automati_]ly adjusts the wash time for the other operating conditions.
Musty or mildewy odor in washer
Check if,,.
Incorrector too much detergent has been used,
Insideof tub not cleaned pro_r]y.
Then,,,
This is normal. The washer adjusts cycle time automatically to provide optimal resuBtsfor the selected cycle. The time remaining shown in the display is only an estimate. Actual time may vary.
Then,,,
Use only HE
Run the CLEAN WASHER cycle regularly. Be sure to wipe around and under the door seal frequently. See Care and Cleaning of the Interiorin Care and Cleaning on page 21.
Clean around door seal/glass to prevent odor or mildew:
1, Wipe dry the door seal/glass and the door opening area
2, Wipe around the inner drum/door seal and the lower door sea]
3.For
Check if,,. | Then,.. |
Washer not unloaded promptly, | Always remove items from the washer as soon as the cycle is |
| _mplete. |
Washer overloaded. | The washer can be fully loadedbut the drum should not be tightly |
| packed, and the door should close easily. |
Hot and cold water inlet hoses are reversed, | Hot water rinse can set wrinkies in garments, Che_ the inlet hose |
| _nnections,. |
27