Kenmore 796.4027 manual Connecting the Water Lines

CONNECTING THE WATER LINES

•IMPORTANT: Use new hoses when installingthe washer. Do NOT reu_ old hoses.

•IMPORTANT: Use ONLY the inlet hoses provided with this laundry product. Aftermarket hoses are not guaranteed to fit or function correctly. Other hoses may not tighten correctly and could cause leaks. Subsequent damage to productor property will not be covered under the terms of the productwarranty.

•Water supply pressure must be between 14.5 PSI and 116 PSI (100,_800 kPa). If the water supply pressure is more than 116 PSI, a pressure reducing valve must be installed.

•Periodically check the hose for cracks, leaks, and wear, and replace the hose if necessary.

•Make sure that the water lines are not stretched, pinched, crushed, or kinked.

•The washer should never be installedor stored [n a

location subject to freezing temperatures. Damage to the water lines and internal mechanisms of the washer can

result. If the washer was expo_d to freezing temperatures priorto installation, allow it to stand at room temperature for several hours before use and che_ for leaks priorto operation,

1.Inspect the threaded fitting on each hose and make sure there is a rubber seal [nplace in both ends.

fw--

For cold water For hot wate_

Water inlets

2.Attach the red, hot water line to the hot water inlet on the back of the washer. Attach the blue, cold water line to the cold water inlet on the back of the washer. Tighten the fittings securely,

NOTE: Be careful not to cross-thread the hose fittings since this will damage the valve and could result in property damage from leaks.

3._nnect the water supply hoses to the HOT and COLD water faucets tightly by hand and then tighten another

2/3 turn with pliers. Turn on the water faucets and check for leaks,

9