BEFORE CALLING FOR SERVICE
The display shows:
Check if...
Loadis too sma&
Load is out of balance.
The display shows:
Ch_k if...
Control error.
iiiii ii ii i!ii!ii!i ii!iiiiii!
ijjii!ii!!!!!ii i!i!!ili! FE
The display shows:
Check if...
iiiiiiiiiiiiiiiiiiiiiii!iiiii!i iiii!i!ili!ii!iiii
iiiiiiiiiiiiiiiiiiiiiiiiiii,I Water leveliiiiiiiiis tooiihighii_ilidue to a fau_j water valve.
The display shows: | pE I |
Check if...
I The water level sensor is not working correcUy.
(conL)
Then,,,
Add 1 or 2 similar items to help balance the Ioa&
Pause the cycle and redistribute the load after the door unl_ks.
The washer has an imbalance detection and correction system If individual heavy articles are loaded (bath mat, bath robe, etc) and the imbalance is too great, the washer wi]] make severai attempts to restart the spin cycle. Jfan imbalance is still detected, the washer wi]] stop and the error code will be displayS.
Then...
Unplug the washer and wait 60 seconds. Reconnect power and try again. If the error reappears, call for service.
Then.,,
IClose the water taps, unplug the washer, and call for service.
Then,.
IClose the water taps, unplug the washer, and ca][for service.
The display shows: | LE |
Check if... |
|
Thermal overload protection drcuit in the motor has been tripped.
The display shows:
Check if.,,
A powerfailure has o_urred.
Then,,,
Allow the washer to stand for 30 minutes to allow the motor to cool; then restart the cycle. If the LE error code persists, call for service.
Then,,,
If the power to the washer has been interrupted during a cycle, the "PF" error code wi]]be displayed the next time the washer is turned on. This will alert you to the fact that the previous cycle may not have been completed. Select any cycle to dear the error code and use the washer.
28
