CONNECTING THE DRAIN HOSE
•The drain hose should always be properly secured Failure to properly secure the drain hoe can result Jn flooding and property damage.
•Do not in,aft the end of the drain hose higher than 96 in. (244.8 cm) above the bottom of the washer.
•The drain must be installed in accordance with any applicable local _des and regulations.
•Make sure that the drain hose is not stretched, pinched, crushed, or kinked.
NOTE:
A drain hose extension kit is available if the drain hoe is not long enough. Do not extend drain hoe more that 6 feet, as this wifl cause poor draining resumingJnpoor wash and spin performance.
Option 1: Standpipe
Elbow Bracket
The elbow bracket should be installed near the end of the drain hoE. Insert the end of the drain hose into the standpipe. Use tie strap to secure the drain hose in place. NOTE:
•Total height of the hose end should not exceed 96 in. (244.8 cm) from the bottom of the washer.
•The drain hose should be inserted no more than
inches into the standpipe.
NOTE: Ifthe drain hose is extended more than 4 inches beyond the end of the end of the elbow bracket, mold, or microorganisms could spread to the inside of the washer.
Option 2: Laundry Tub
Elbow Bracket
The elbow bracket should be installed near the end of the drain hose. Hang the end of the drain hose over the side of the laundry tub. Use tie strap to secure the drain hoe in place.
Option 3: Floor Drain
Drain Hose
Floor Drain
,,,J
insert the end of the drain hose into the floor drain. Secure the hose to prevent it from moving.
CONNECT TO POWER SUPPLY
Washer should be plugged into a
Plug in the washer.
J
10
