Kenmore 9743680, 9743679, 9743678, 9744231 dimensions Drain hose, 11 11a 11b, continuedfrompage

10.

11.

11a.

11b.

continuedfrompage 10

Drain hose

Cut a 1-1/2" (3.8cm) diameter hole in cabinet wall or floor on the side of the

opening closest to the sink.

Connect drain hose to waste tee or waste disposer following one method.

If youhave:	and:	gotostep:
a wastedisposer	an air gap	11a.
	no air gap*	11c.
nowastedisposel	anair gap	11b.
	noair gap*	11d.

*an air gapis recommended

1.Remove the disposer knockout plug. Cut end of drain hose O if needed

(do not cut ribbed section).

2.Attach drain hose to air gap • with spring-type clamp O.

3.Use a rubber hose connector* • with spring or screw-type clamps* _) to connect air gap to disposer inlet O.

This connection O MUST be before

drain trap _) and at least 20" (50.8cm) above the floor where dishwasher will

be installed. Go to step 12.

1.Cut end of drain hose O if needed (do not cut ribbed section).

2.Attach drain hose to air gap O with 1-!/2"-2" (3.8-5cm) screw clamp.

3.Use a rubber hose connector* •

with spring or screw-type clamps*

_) to connect air gap to waste tee _). This connection _ MUST be before drain trap (D and at least 20" (50.8cm) above the floor where dishwasher will be installed. Go to step 12.

11