Kenmore 9744231, 9743680, 9743679, 9743678 dimensions If you are installing a power supply

_f L: t t: .f; ]

1

Apply Teflon tape or ptpe jo=nt compound • to 90 ° elbow httmg 0 and connect fitttng to water =nletvalve

0.Hold bracket (_ with phers Ttghten elbow unttl snug, and be sure that tt faces to the rear.

Remove terminal box cover _ Pull apphance wtres@ through hole m termmal box

If you are direct wiring: install a U L.- hsted/CSA-certd_edclamp connector @ to the terminal box If using condu_t, use a U L -listed/CSA-certtfied conduit connector.

If you are installing a power supply

cord kit, do so now and follow kit instructions.

HELPFUL TIP:

Put cardboard under dishwasher until it is installed in cabinet opening. The cardboard will help protect floor covering during Installation.

Measure hetght of cabinet opening from underside of countertop to floor where dishwasher will be installed 0 (you need the lowest point) Check chart for that hetght openmg Put wheels (D in the requtred posttion.

MIn.	Wheel position
c.tou! height	(see illustration)
34- (86.4cm)	1
34-1/8"(86.7cm)	2
34-511S"(87 2cm)	3
34-1/2"(87.6cm)	4

continuedon page15 14