2.Place dryer rack over the bottom of the dryer door opening. Rest the back wire on the dryer back ledge. Push down on the frame front to secure over lint screen.
3= Place wet items on top of the rack. Allow space around items for air to circulate. The rack does not move, but the drum will rotate. Make sure items do not hang over the edges or between rack grille.
4.Close the door.
5.Select TIMED DRY and MORE TIME or LESS TIME. Reset
time as needed to complete drying. Refer to the following table.
6.Select the desired temperature setting to match the fabrics in your load by pressing TEMPERATURE. Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Dry temperature setting. Refer to the following table.
7.Start the dryer.
NOTE: You must remove rack for normal tumbling. To remove the dryer rack, lift it straight up and out of the dryer.
NOTE: Check the lint screen and remove any lint accumulated from items dried on the rack.
Suggested | Items for | Rack | Temperature | Suggested | |
Drying |
|
|
| Setting | Time* |
|
|
|
|
| (Minutes) |
Washable | wool items | (block | Low | 20 | |
to shape and lay flat on |
|
| |||
rack) |
|
|
|
|
|
Stuffed toys | (cotton or | Low | 20 | ||
polyester | fiber filling) |
|
|
| |
Stuffed toys | (foam rubber | Air Dry | 50 | ||
filled) |
|
|
|
|
|
Galoshes | (rubber) |
| Air Dry | 20 | |
Foam rubber pillows |
| Air Dry | 50 | ||
Tennis shoes |
| Air Dry | 20 | ||
*Reset time as needed to complete drying.
DRYER CARE
Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 era) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
Every load cleaning
The lint screen is located in the door opening of the dryer. The
control panel has an indicator light to remind you to clean the lint screen before or after each load. A screen blocked by lint can increase drying time.
To clean
1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.
2.Push the lint screen firmly back into place.
IMPORTANT:
•Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may shed more lint than other towels, causing your dryer's lint screen to fill up faster. Be sure to remove lint from the lint screen before and after drying new towels.
•If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See "Venting Requirements."
18
