English
Use the centrifugal juicer for extracting juice from fruit and vegetables.
before using your Kenwood attachment
●Read these instructions carefully and retain for future reference.
●Remove all packaging and any labels.
safety
●Do not use the juicer if the filter is damaged.
●The cutting blades on the base of the filter are very sharp, take care when handling and cleaning the filter.
●Only use the pusher supplied. Never put your fingers in the feed tube. Unplug before unblocking the feed tube.
●Before removing the lid, switch off and wait for the filter to stop.
●Switch off and unplug:
●before fitting or removing parts
●before cleaning
●after use.
●Never use a damaged machine. Get it checked or repaired : see ‘service’.
●Never use an unauthorised attachment.
●Never leave the machine on unattended.
●Don't touch moving parts.
●This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.
●Do not use the lid to operate the attachment, always use the on/off speed control.
●Should excessive vibration occur when using this attachment, either adjust the speed or stop the machine, unplug and clear any blockage.
●Do not let infirm people use the appliance without supervision.
●Do not let children use or play with the appliance.
●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
before using for the first time
1 Wash the parts: see 'Cleaning'.
key
pusher
lid
lid interlock tab filter
pulp container juice outlet
pulp container release lever base unit
beaker beaker holder
to use your centrifugal juicer
preparing food
●Remove stones (plums, peaches, cherries etc).
●Remove tough skins (melons, pineapples, cucumbers, potatoes etc).
●
●Citrus peel - Peel and remove the white pith, otherwise the juice may be bitter. For best results we recommend using the citrus juice attachment which is available separately.
●Remove high speed outlet cover before assembling unit.
assembly and use
1Place the pulp container onto the base unit and turn clockwise until it locks into position. When correctly fitted the spout should be located over the pulp container release lever.
2
