System connections

Connection of the system accessories

This figure shows the method of connection between the main unit and provided accessories.

Preparations

Basic section

CAUTION

Connect the components as shown in the diagram. Only plug the AC power cord into an AC wall outlet once connections are completed.

CAUTION

The magnet in the speaker may cause color irregularity to the TV or PC monitor. Place the speakers farther away from the TV set or PC monitor.

CAUTION

Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard.

÷Place the C-AX7on top of the system.

÷Do not place any objects impairing heat radiation onto the top of the unit.

÷Leave some space around the unit (from the largest

outside dimension including projection) equal to or greater than, shown below.

Top panel : 50 cm Back panel : 10 cm

÷Do not place the equipment onto a bed, a sofa, a carpet, or similar. Sucked-in dust can cause fire.

CAUTION

The power in this equipment will not be completely cut off from the wall outlet when the power switch is turned off.

Install the equipment so that the wall outlet is easily accessible and, in case of emergency, immediately unplug the power cord from the wall outlet.

Malfunction of microcomputer

If operation is not possible or erroneous display appears even though all connections have been made properly, reset the microcomputer by referring to "In

case of difficulty".

D

 

 

Speaker (Right)

 

− +

− +

Application section

Knowledge section

How to connect the speaker cords

1

2

3

4

Speaker cord (Blue line) for surround

 

 

 

 

Speaker cord (Red line)

÷Never short-circuit the "+" and "–" speaker cords. It may cause malfunction.

÷ If the "+" and "–" polarity are inverted, the sound will be unnatural with unclear positioning of musical instruments, etc.

÷Be sure to insert all connection cords securely. If their connections are imperfect, the sound may not be produced or noise may interfere.

÷Before plugging or unplugging a connection cord, be sure to unplug the power cord from the wall AC outlet. If connection cords are plugged or unplugged with the power cord left plugged in, malfunction or damage may result.

÷Set up the left and the right speaker so that the front surround speakers face to the inside, paying attention to L and R.

÷When pulling the plug of the power cable from the wall outlet, first switch off the unit.

8 EN