4

8Once setup codes have been entered for all components,

hold down the ENT key until the backlight flashes twice.

• Once registered, the display on the receiver shows the component

Getting the most from your remote control

RC-R0507 (En/T)

Operating other components

This operation lets you operate the registered components. KENWOOD audio components with system control turn on and off automatically with the receiver via the system control connections.

POWER

type instead of the default input name.

Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears

instead of "VIDEO 1 (VCR1)".

• After initial setup, any VIDEO or TV (TV1, TV2, CABLE) inputs that

have not been programmed with a setup code or Non-IR code are

deleted from the cyclic list. The PHONO input will be deleted if a

Non-IR code was not registered.

• The INPUT SELECTOR on the front panel of the receiver always

cycles through all inputs.

VIDEO, AUDIO, TV

SHIFT

Note

Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also, certain codes may only operate some of the functions available on a given model.)

1Use the VIDEO, AUDIO, or TV keys to select the compo- nent you desire.

•Pressing the VIDEO or AUDIO key also changes the input selector on the receiver. If you do not want to change the current input,

 

press the SHIFT key before step 1.

 

 

RC5

VIDEO key

AUDIO key

TV key

 

 

 

1 VIDEO1 (VCR 1)

 

 

1 CD (CD)

 

 

1 TV1

 

 

 

 

 

 

 

2 VIDEO2 (VCR 2)

 

 

2 TAPE or MD

 

 

 

2 TV2

 

 

 

 

 

 

 

 

 

 

 

 

3 VIDEO3 (DVD)

 

 

(TAPE)

 

 

 

3 CABLE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

or DVD 6ch

 

 

3 TUNER

 

 

 

 

 

 

4 Not used by this

 

 

4 PHONO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

remote control.

 

 

 

 

 

 

 

(<--->)

 

 

 

 

 

 

 

2Press the SHIFT key and then press the POWER key (within 3 seconds).

•Pressing the SHIFT key is only required when turning the selected component on or off. Pressing the POWER key directy turns the receiver on and off.

3Press the operation keys you desire.

•See "Remote operation of other components" at the end of this manual for a list of keys available with each component.

RC$

The remote control mode remains in the set at the component selected in step 1 mode until you select another component (etc.).

Note

Be sure to point the remote control at the remote sensor on the receiver when you want to operate KENWOOD components connected by system control cords. Otherwise, point the remote control at the component you want to operate.

Control Remote