Kenwood BLM80 manual troubleshooting guide, Problem, Cause, Solution

troubleshooting guide

Problem	Cause	Solution
The Blender will not operate.	No Power/Power On Light not	Check blender plugged in.
	illuminated.
	Goblet removed from power unit	The power unit will not operate until
	without turning the speed control	the speed control is turned to “on”
	to “O”.	and a speed is reselected.
	Blender not assembled correctly.	Check blade unit is fully tightened to
		the goblet.
Power on light flashing rapidly.	The lights will flash under the
	following circumstances:-
	The power unit is plugged in but the	Fit the goblet.
	goblet is not fitted to the power unit.
	The goblet is removed from the power	The power unit will not operate until
	unit without turning the speed control	the speed control is turned to “O”
	to “O”.	and a speed is reselected.
Power On Light flashing slowly.	The blender has been left plugged in	Turn the speed control on and then
	for more than 15 minutes and has	off or press a program button to
	gone into standby mode.	reset.
Blender not operating but Power	Goblet fitted and speed control	Either select a speed manually or
On and programme button	turned to “on” but speed or	press one of the programme buttons.
lights on.	programme not selected.
Programme lights flashing	The lights will flash under the
	following circumstances:-
	The power unit is plugged in but	Fit the goblet.
	the goblet is not fitted to the power
	unit.
	The goblet is removed from the power	Turn the speed control to “O” and
	unit without turning the speed control	reselected a speed.
	to “O”.
Programme buttons not operating	Programme buttons will not operate	Turn the speed control to “on” and
	unless the speed control is turned to	select the required programme.
	the “on” position first.
Blender leaking from blade	Seal missing.	Check seal is fitted correctly and not
assembly.	Seal incorrectly fitted.	damaged. To obtain a replacement
	Seal damaged.	seal see “service & customer care”.
Blender seal missing from blade	The seal is packed pre-fitted to	Unscrew goblet and check that seal
unit when removed from	the blade unit.	is fitted to blade unit.
packaging.		To obtain a replacement seal see
		“service & customer care”.
Blender stops or slows during	Overload protection operated.	Switch off, unplug for 5 seconds.
processing.	Blender overloaded or overheated	Then plug back in. If blender does
	during operation.	not operate then leave to cool for
		15 minutes before plugging back in.
	Maximum capacity exceeded.	Refer to the speed chart for
		maximum capacities to process.
If none of the above solve the problem see “Service & Customer Care”.

9