Kenwood BLM80 manual Key, To use your blender, Before plugging, Important UK only

before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of the appliance.

Important – UK only

●The wires in the cord are coloured as follows: Green and Yellow = Earth, Blue = Neutral, Brown = Live.

●The appliance must be protected by a 13A approved (BS1362) fuse.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.

key

1filler cap

2 lid

3 goblet

4 sealing ring

5 blade unit

6 blade base

7 Power On indicator

8 speed + pulse control

9 power unit

k drinks programme button l soups programme button m ice crush programme button n fine chop programme button

o coarse chop programme button p rinse programme button

q vents r stir stick

s cord storage device

to use your blender

1Fit the sealing ring 4 into the blade unit 5 - ensuring

the seal is located correctly in the grooved.area. Then fit the blade unit into the goblet 3

● Leaking will occur if the seal is damaged or incorrectly fitted.

2 Screw the blade base 6 onto the goblet – ensuring the blade assembly is fully tightened. Refer to the graphics on the side of the blade base as follows:

- unlocked position

- locked position

3Put your ingredients into the goblet.

4Fit the filler cap to the lid and push down to secure.

5Fit the lid by pushing down until secure.

6Place the blender onto the power unit.

● Ensure the cord is fully unwound from the cord storage device before using the blender.

● The appliance will not work if the blender is incorrectly fitted.

7 Plug in and the Power On indicator 7 will light up. Note: The Power On indicator will flash if the goblet is not fitted to the power unit. Select a speed (refer to the recommended speed chart).

8 Choose one of the following options:

●Programme buttons:- Turn the speed control to the ‘On’ position and all the buttons will light up. Press the required programme button and the lights on the other buttons will go out and the programme will start. The blender will switch off automatically at the end of the programme time. If you wish to stop before the programme time has elapsed, press the selected programme button again.

●Manually selected a speed by turning the speed control until the required speed is reached. At the end of blending return the speed control to “O” before removing the blender.

●Do not remove the goblet until the blades have stopped rotating and the speed control is in the ‘O’ position.

●(P) Pulse – operates the motor in a start/stop action. The pulse will operate for as long as it is held in position.

Refer to the troubleshooting section if you experience any problems with the operation of the blender.

5