Kenwood DPX501U, DPX701U Range, Display, Display, Audio Setup, Speaker type, 1Enter Standby, Speaker Setting, 5Exit Audio Setup mode, 2Enter Audio Setup mode

General features

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup modePress the [VOL] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item	Display	Range
Front High Pass Filter*2	"HPF-F Fc"/	Through/40/60/80/100/120/
	"HPF"	150/180/220 Hz
Rear High Pass Filter*2	"HPF-R Fc"/	Through/40/60/80/100/120/
	"HPR"	150/180/220 Hz
Low Pass Filter*1,2	"LPF-SW"/	50/60/80/100/120/
	"LPF"	Through Hz
Subwoofer Phase*1,2,3	"SW Phase"/	Reverse (180°)/ Normal (0°)
	"PHAS"
Volume offset	"Vol-Offset"/	–8 — ±0
	"V-OFF"
Loudness	"LOUD"	OFF/ON
Dual Zone System	"2 ZONE"/	OFF/ON
	"2ZON"

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume.

•*1 You can control this item when <Switching preout> (page 37) is set to "SWPRE SW". (DPX501U only)

•*1 You can control this item when <Subwoofer Output> (page 15) is set to "SW ON".

•*2 You can control this item when "2 ZONE"/ "2ZON" of <Audio Setup> (page 14) is set to "OFF".

•*3 You can control this item when Low Pass Filter is not set to Through.

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by <Dual Zone System Setting> (page 37).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 12).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the internal auxiliary input.

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Speaker Setting mode Press the [VOL] knob.

"SP SEL"/ "SP" is displayed.

3Select the Speaker type Turn the [VOL] knob.

Each time you turn the knob, the setting alternates between the settings shown in the table below.

Speaker type		Display
OFF		"OFF"/ "SP OFF"
For 5	& 4 in. speaker	"5/4 inch"/ "SP 5/4"
For 6	& 6x9 in. speaker	"6x9/6 inch"/ "SP 6*9/6"
For the OEM speaker		"O.E.M."/ "SP OEM"

4Exit Speaker Setting mode Press the [VOL] knob.

14 English