Troubleshooting Guide

Audio file source

?Cannot play an Audio file.

✔The media is scratched or dirty.

☞Clean the media, referring to the CD cleaning of the section on <About CDs> (page 7).

?The sound skips when an Audio file is being played.

✔The media is scratched or dirty.

☞Clean the media, referring to the CD cleaning of the section on <About CDs> (page 7).

✔The recording condition is bad.

☞Record the media again or use another media.

?The Audio file track time isn’t displayed correctly.

✔---

☞There are times when it isn’t displayed correctly according to the Audio file recording conditions.

USB device source

?The USB device is not detected.

✔The USB connector is disconnected.

☞Connect the connector of the USB device properly.

?The USB device does not play its audio files.

✔The USB connector is disconnected.

☞Connect the connector of the USB device properly.

The messages shown below display your systems condition.

Eject/ EJECT: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.

➪Load the disc magazine properly. No CD in the unit.

➪Insert the CD.

No Disc/ NO DISC:

No disc has been loaded in the disc magazine.

➪Load a disc into the disc magazine.

TOC Error/ TOC ERR:

No disc has been loaded in the disc magazine.

➪Load a disc into the disc magazine. The CD is quite dirty. The CD is upside- down. The CD is scratched a lot.

➪Clean the CD and load it correctly.

Read Error/ READ ERR:

•The number of files or folders which are stored in the connected USB device is above the limitation.

•The file system of the connected USB

device is broken.

➪Copy the files and folders for the USB device again referring to www. kenwood.mediamanager.jp. If the error message is still displayed, initialize the USB device or use other USB devices.

Error 05/ E-05: The CD is upside-down.

➪Load the CD correctly.

Blank Disc/ BLANK:

Nothing has been recorded on the MD.

No Track/ NO TRACK:

No tracks are recorded on the MD, although it has a title.

Error 15/ E-15: Media was played that doesn’t have data recorded that the unit can play.

➪Use media that has data recorded that the unit can play.

No Panel/ NO PANEL:

The faceplate of the slave unit being connected to this unit has been removed.

➪Replace it.

Error 77/ E-77: The unit is malfunctioning for some reason.

➪Press the reset button on the unit. If the "Error 77/ E-77" code does not disappear, consult your nearest service center.

56 English