Kenwood DV-5900M C :, d :

Chapter 6 Chapter 5 Chapter 4 Chapter 3 Chapter 2 Chapter 1

Chapter 1: Connection of Equipment

C : Component video connection

If the TV has component video input terminals, connect the Y, CB and CR COMPONENT VIDEO OUTPUT terminals to the corresponding jacks on the TV using video cables.

¶As component video separate video signal into the brightness signal (Y) and color difference signals (CB, CR), it can provide sharper image than the S Video connection.

¶Depending on the TV or video monitor in use, the terminal names may be different from those used with the player (Y/Pb/Pr or Y/B-Y/R-Y, etc.)

¶When the TV in use is a HDTV or "Hi-Vision" TV, connect the component video signals from the player only to the DVD-compatible input jacks.

	COMPONENT
	VIDEO IN
	Y	Cb Cr
			Video cable
COMPONENT VIDEO			S VIDEO		VIDEO
INPUT	OUTPUT			OUTPUT
INPUT	OUTPUT		INPUT OUTPUT
				COMPONENT
				VIDEO
Y C B C R	Y	C B C R	1	OUTPUT	1
Y C B C R	Y	C B C R	1	2
					2
				INTERLACE PROGRESSIVE

Illust Model : DV-5900M

COMPONENT VIDEO OUTPUT switch (NTSC Format only)

d : SCART connection (For Europe and U.K.)

If the TV or VCR has SCART connectors, connect the TV SCART or VCR SCART connector of this unit to the TV or VCR using SCART cables.

¶The audio and video signals can be output using a single cable. The signal output from the TV SCART connector can be switched between composite video, S Video and RGB. (The VCR SCART connector always outputs composite video signals so its output signals cannot be selected.)

¶When the TV is connected through a VCR using SCART connection, the picture displayed on the TV may be disturbed due to the copy protect function.

¶When using only the TV and VCR which are both connected with the player using the SCART connection, the signal from the VCR cannot be sent to the TV if the player is switched off. (In this case, set the player to the power standby mode.)

¶When the COMPONENT VIDEO OUTPUT connectors are used, do not set

“SCART Output Select” in the Set Up menu to “RGB”.

SCART IN

SCART cable

SCART IN

TV SCART

Chapter 8 Chapter 7

S V I D E OVIDEO

INPUT OUTPUTOUTPUT

1	2	1
		COMPONENT

VIDEO

OUTPUT

INTERLACE PROGRESSIVE

Select the scanning method of the Component Video output using the COMPONENT VIDEO OUTPUT switch on the rear panel.

INTERLACE : Scanning method is fixed at interlaced scanning.

PROGRESSIVE :Whenprogressivescanningisunavailablewith certain discs, the scanning method is switched automatically to interlaced scanning. When the unit is performing progressive scanning, “PROGRESSIVE” light in the display.

VCR SCART

DIGITAL	DAISY CHAIN	AUDIO	COMPONENT VIDEO	VCR etc.
(PCM/BIT STREAM)	MIX LINE	6 C H . I N P U T
	MIX LINE	6 C H . I N P U T