Playback of TAPE
19 EN
To wind tape at high speed
÷Press the STOP 7 key to stop fast winding.
÷The same operation is also available with the 4
and ¢ keys on the main unit.
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1"TAPE EQ." lights
(TAPE equalizer is used)
2"TAPE EQ." goes off
(TAPE equalizer is not used)
Lit when "TAPE EQ." is ON
÷Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
Selection of reverse modeTo stop playback
The tape counter is set to "0000" when a cassette
tape is loaded. By writing down the counter read-
ing in case you want to interrupt recording (play-
back) in the middle of the tape, the memo will be
helpful as a reference for locating the same posi-
tion when continuing the recording (playback) the
next time. The tape counter figure decreases dur-
ing recording or playback of the back side (while
the 2 tape transport indicator is lit). To set the tape
counter to "0000", open the cassette holder once.
Then the counter will be reset.
A tip for use of the tape counter
1Select "TAPE RVS".
2Select.
3Set it.
1" " : (ONE-WAY)
Only one side is played back (recorded), and
then the tape stops.
2" " : (REVERSE)
Both sides are played back (recorded), and
then the tape stops.
3" " : (ENDLESS)
Both sides are played back endlessly. (The
tape stops after recording onto both sides.)
(The initial setting is " "(REVERSE))
Main unit only
To fast wind in
direction \
To fast wind in
direction |
1
1
TUNING
TAPE EQ.
STOP 7
AUTO/MONO
\
\\
\
mode
set/sound
set/sound