Connection

■Terminal names

40

7 8 9 0

!

@ # $

%

7Fuse (40 A)

NOTE

If you can’t find the specified capacity fuse at your store etc., consult your Kenwood dealer.

8Battery terminal9Ground terminal0Power control terminal

Controls the unit ON/OFF.

NOTE

Controls the unit power. Be sure to connect it with all the systems.

!Speaker output terminals

As this unit accepts speakers with a minimum impedance of 1 ohm, connect speakers with 1- ohm or higher impedance to these terminals.

2CAUTION

%Speaker level input terminals

NOTE

•The genuine-accessory car stereo shall have a maximum power output of no more than 40 W.

•Do not connect the speaker output leads from a power amplifier (Optional) to the speaker level input terminals of this unit, for this may cause malfunction or damage.

•Do not connect cables and leads to both RCA cable input jacks and the speaker level input terminals simultaneously, for this may cause malfunction or damage.

•Connect the power control lead to a power supply which can be turned ON/OFF by the ignition key switch (ACC line). With this connection, shock noise may be generated when the power of the genuine-accessory car stereo is switched ON/OFF.

The rated input of the speakers should be no less than the maximum output of the amplifier. Otherwise malfunction may result.

@RCA cable ground lead terminal

When using an RCA cable with a ground lead attached, connect the ground lead to this terminal.

#LINE IN terminal$LINE OUT terminal

The signal that’s input from the line input terminal is output.

6English