Installation

■ Removing the hard rubber frame

English

1 Engage the catch pins on the removal tool and remove the

 

 

two locks on the lower level.

 

Lower the frame and pull it forward as shown in the figure.

 

Catch

 

Lock

Accessory2 Removal tool

2When the lower level is removed, remove the upper two locations.

NOTE

The frame can be removed from the top side in the same manner.

■Removing the Unit

1Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.

2Remove the screw (M4⋅8) on the back panel.

3Insert the two removal tools deeply into the slots on each side, as shown.

Screw (M4X8)

Catch facing up

(commercially

 

available)

 

 

Accessory2 Removal tool

4Lower the removal tool toward the bottom, and

pull out the unit halfway whilst pressing towards the inside.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

5Pull the unit all the way out with your hands, being careful not to drop it.

— 30 —