Getting started
Canceling the display demonstration
The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB]
1Press the volume knob.
[YES] is selected as the initial setup.
2Press the volume knob again to confirm. [DEMO OFF] appears.
If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] in step 2, [DEMO MODE] appears and the display demonstration starts.
Setting the demonstration mode
1Press the volume knob to enter [FUNCTION].
2Turn the volume knob to select [DEMO MODE], then press to enter.
3 Turn the volume knob to select [ON] or [OFF].
If [ON] is selected, display demonstration starts if no operation is done for about 20 seconds.
4 Hold 
to finish the procedure.
Adjusting the clock
1Press the volume knob to enter [FUNCTION] mode.
2Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to select [CLOCK], then press to enter.
4 Turn the volume knob to select [CLOCK ADJUST] / [CLOCK ADJ], then press to enter. Clock hour flashes on the display.
5 Turn the volume knob to adjust the hour, then press to enter minute adjustment. Clock minutes flashes on the display.
6 Turn the volume knob to adjust the minute, then press to confirm. Press 4 / ¢ to move between the hour and minute adjustment.
7 Hold 
to finish the procedure.
Initial settings before operations
1Press 
SRC to enter [STANDBY] mode.
2Press the volume knob to enter [FUNCTION] mode.
3Turn the volume knob to select [INITIAL SET], then press to enter.
4 Turn the volume knob to make a selection, then press to confirm. See table on page 8 for selection.
5 Hold 
to finish the procedure.
ENGLISH
Continued...
7
