— 39 —
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1Refer to the section <Removing the hard rubber frame> (page
40) and then remove the hard rubber frame.
2Drop open the faceplate by pressing the Release button.
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
4Tighten the screws (ø2 × 4 mm) (Accessory 6) in the holes
shown on the diagram.
Accessory7
5Tighten the screws (ø2 × 6 mm) (Accessory 7) in the holes
shown on the diagram.
Accessory6
3Tighten the screws (ø2.6 × 12 mm) (Accessory 5) in the holes
shown on the diagram.
Accessory5
KDC-MPV7023_U.S r2 02.10.31 10:16 AM Page 39