Menu settings

English

Code Security Function

After a security code has been registered, power cannot be restored if the battery is disconnected from the unit unless the code is first input.

NOTE

All the steps in this procedure (1 through 8) must be completed before the code security function can be turned on. However, once the procedure is finished, it need not be repeated.

Once the code security function has been activated, "Security / SECURITY" disappears from the MENU system. Note that it will no longer be possible to cancel this function afterwards.

1Press the SRC button repeatedly to select the standby mode. "ALL OFF" is displayed when the standby mode is selected.

2Hold down the MENU button for one second or more. "MENU" is displayed and the menu mode is turned on.

3Press the FM button repeatedly until "Security/SECURITY" appears in the display.

Press the AM button to search in the other direction.

4Hold down either the 4 or ¢ button for two seconds or more.

"ENTER" will appear in the display for one second, indicating the code setting mode has been entered. When "CODE" appears in the display, you can start inputting the code.

5Press the preset button and enter your security code. Use the security code shown on your Car Audio Passport. Example: Enter "3510" as your code, pressing the buttons as follows:

Step

Button to press

# Times

Display

pressed

 

 

 

1

#1

4

“3”

2

#2

6

“5”

3

#3

2

“1”

4

#4

1

“0”

6Hold down the DISP button for three seconds or more.

The security code will be set.

"RE-ENTER" will appear in the display for one second, asking you to enter the code once again for confirmation. When "CODE" appears in the display, you can start inputting the code.

7Press the Preset button and input the security code again.

8Hold down the DISP button again for three seconds or more. "APPROVED" will appear in the display, with the code security function turning on. From this point on, if the unit is disconnected from the battery, the security code must be entered the first time that the unit's power is turned on. "ENTER" and "CODE" will appear in the display, asking you to input the code.

NOTE

If you input an incorrect security code, the code setting mode will be cancelled automatically. Follow the steps from 4 to 8 above again.

If you press the RESET button or remove the battery:

The first time you turn the unit on again, "CODE" will appear in the display, asking you to input the security code.

Repeat steps 7 and 8 above, and input the security code. You can start operating the unit again when "APPROVED" appears in the display.

NOTE

If you enter the wrong code, "WAITING" is displayed and you cannot make further input of the code for a fixed interval (see table below), which grows longer each time you enter the wrong code.

When "CODE" is displayed, you can make input again.

Number of wrong

Interval until next input

inputs

is allowed

1

-

2

5 minutes

 

 

3

1 hour

4

24 hours

 

 

The number of wrong inputs is displayed.

— 28 —