Kenwood KDC-5070R, KDC-6070R E-04, E-77, E-99, HOLD, EJECT, BLANK, NO DISC, NO TRACK, NO PANEL, ]Replace it, all operation, ]Insert the CD, Load a disc into the disc magazine

The following messages are displayed when certain problems are occurring in your system. Take the recommended actions.

EJECTNO DISCE-04BLANKNO TRACKNO PANELE-77E-99

No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.

]Load the disc magazine properly. No CD in the unit.]Insert the CD.No disc has been loaded in the disc magazine.]Load a disc into the disc magazine.

No disc has been loaded in the disc magazine.

]Load a disc into the disc magazine.

The CD is very dirty. The CD is upside-down. The CD is scratched a lot.]Clean the CD and load it correctly.Nothing has been recorded on the MD.]The next MD is automatically played backNo tracks are recorded on the MD, although it has a title.]The next MD is automatically played back.The faceplate of the slave unit being connected to this unit has been removed.]Replace it.The unit is malfunctioning for some reason.

]Press the reset button on the unit. If the "E- 77", code does not disappear, consult your nearest service centre.

Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.

]Check the disc magazine. And then, press the reset button on the unit.If the "E- 99" code does not disappear, consult your nearest service center.

HOLD	The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F), stopping
	all operation.

]Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the disc starts playing again.

— 37 —